Ramsey Winch 60K WILDCAT WINCH - Manual (Page 9)

8 OM-914214-0609-D
5. Remove motor #45 from winch by first disconnecting hydraulic lines (see page 21), solenoid
wires, and then remove (4) bolts #37. O-ring #72 may now be removed.
6. Remove brake cover #42 by removing (4) bolts #66. The cover is spring loaded, use care
when removing. Remove o-ring #46 then springs #61 may be removed; residual oil may be
present in the brake housing.
7. Remove piston #11 including o-rings and backup rings #47, #48, #49, and #50 by using a
momentary puff of compressed air into the brake port located on top of the end bearing.
Capture the piston by placing a shop rag over the opening prior to using air.
8. Remove the sprag brake hub assembly #40, (7) stator plates #12, (6) disc brakes #13, and the
spacer #28. The sprag brake hub assembly #40 is not a serviceable part, if damaged a
replacement assembly should be ordered.
40
28
12
13
48
47
11
49
50
61
46
42
66
72
45
37
63