Ramsey Winch 60K WILDCAT WINCH - Manual (Page 17)

16 OM-914214-0609-D
ASSEMBLY OF INPUT CARRIER
Note: Item Numbers refer to Carrier parts list on page 15
1. Place carrier #106 on flat clean surface.
2. Place the gear #101 on a flat thin clean metal plate; Align the bearing with the chamfer facing
toward the gear. Using a press, press the bearing flush to the gear surface.
3. Place thrust washer #102 on top of gear #101. Insert carrier pin #103 into carrier #106,
aligning roll pin #104 with the matching hole on the carrier #106.
4. Insert a thrust washer between gear #101 and carrier #106. Completely insert carrier pin #103
into carrier #106 using care to align the roll pin hole in carrier pin #103 with the roll pin hole in
the carrier #106.
5. Drive roll pin #104 into carrier #106 until roll pin #104 is ¼” past flush with surface of the carrier
#106.
6. Repeat this process to install the two remaining gears into the carrier.