Ramsey Winch 60K WILDCAT WINCH - Manual (Page 5)

4 OM-914214-0609-D
CABLE INSTALLATION
1. Unwind cable by rolling it out along the ground to prevent kinking. Securely wrap end of wire
rope, opposite hook, with plastic or similar tape to prevent fraying.
2. Place taped end of cable around the drum and into the track on drum flange. Secure using
supplied u-bolt #62 and (2) washers #64 and (2) nuts #65.
3. Carefully run the winch in the “reel-in” direction. Keeping tension on end of cable, spool all the
cable onto the cable drum, taking care to form neatly wrapped layers.
4. After installing cable, band brake is used to prevent bird nesting while pulling out cable, when
clutch is disengaged.
62
64
65
INSERT CABLE AS SHOWN