Ramsey Winch 60K WILDCAT WINCH - Manual (Page 18)

17 OM-914214-0609-D
DISASSEMBLY OF INTERMEDIATE CARRIER
Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be
purchased individually (see parts list below). If purchasing individual parts, it will be necessary to
disassemble the intermediate gear carrier as outlined below.
1. Carefully drive roll pin #204 into carrier pin #205 so that it is captured within carrier pin #205
but not touching the opposite side of the intermediate carrier #201.
2. Tap carrier pin #205 to remove it from the intermediate carrier #201.
3. Slide the planet gear #202and the (2) thrust washers #203 from the carrier assembly #201.
Bearings #206 may then be pressed out.
4. Remove the roll pin #204 from the carrier pin #205.
5. Repeat this process for the two remaining gears in the carrier.
ITEM # QTY PART # DESCRIPTION
201 1 317022 INTERMEDIATE CARRIER
202 3 334219 PLANET GEAR
203 6 518075 THRUST WASHER
204 3 470040 ROLL PIN 1/4 DIA X 5/8 LG
205 3 470125 CARRIER PIN
206 6 402140 BEARING-DRAWN CUP NEEDLE ROLLER
201
INTERMEDIATE CARRIER
203
206
205
206
203
204
202