Ramsey Winch 60K WILDCAT WINCH - Manual (Page 3)

2 OM-914214-0609-D
RAMSEY HYDRAULIC PLANETARY WINCH MODEL WILDCAT 60K
PLEASE READ THIS MANUAL CAREFULLY
This manual contains useful ideas in obtaining the most efficient operation from your Ramsey Winch, and safety
procedures one needs to know before operating a Ramsey Winch. Do not operate this winch until you have carefully
read and understand the "WARNINGS" and "OPERATION" sections of this manual.
WARRANTY INFORMATION
Ramsey Winches are designed and built to exacting specifications. Great care and skill go into every winch we make.
If the need should arise, warranty procedure is outlined on the back of your self-addressed postage paid warranty card.
Please read and fill out the enclosed warranty card and send it to Ramsey Winch Company. If you have any problems
with your winch, please follow instructions for prompt service on all warranty claims. Refer to back page for limited
warranty.
SPECIFICATIONS*
APPROXIMATE WEIGHT: 1400 LBS
WORKING PRESSURE: 2600 PSI
CABLE DIAMETER: 1 INCH
MAX FLOW: 60 GPM
LOW SPEED HIGH SPEED CABLE
CAPACITY
LINE PULL LINE SPEED LINE PULL LINE SPEED
LAYER
OF
CABLE
Ft m Lb Kg fpm mpm Lb Kg fpm mpm
1 50 20 60000 27100 31 9 22500 10200 75 23
2 110 43 50000 22600 37 11 18700 8500 90 27
3 180 71 42800 19300 43 13 16000 7200 105 32
4 260 102 37500 16900 49 15 14000 6300 120 37
* These specifications are based on recommended wire rope of 1” Extra Improved Plow Steel Cable and a 7.7
cu. in. / Rev. motor.
NOTE: The rated line pulls shown are for the winch only. Consult the wire rope manufacturer for wire rope ratings.
WARNINGS:
CLUTCH MUST BE FULLY ENGAGED BEFORE STARTING THE WINCHING OPERATION.
DO NOT START WINCH MOTOR BEFORE ENGAGING CLUTCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PEOPLE.
A MINIMUM OF 5 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD.
CABLE ANCHOR IS NOT DESIGNED TO HOLD LOAD.
BAND BRAKE IS NOT TO BE USED TO HOLD LOAD