Ramsey Winch 60K WILDCAT WINCH - Manual (Page 20)

19 OM-914214-0609-D
DISASSEMBLY OF OUTPUT CARRIER
Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be
purchased individually (see below). If purchasing individual parts, it will be necessary to
disassemble the gear carrier as outlined below.
1. Carefully drive roll pin #305 into carrier pin #304 so that it is captured within carrier pin #304
but not touching the opposite side of the output carrier #301.
2. Tap carrier pin #304 to remove it from the output carrier #301.
3. Place a plastic pail in a position to catch bearings #306, spacer #307 and thrust washers #303,
then slide the gear #302 from the carrier #301.
4. Remove the roll pin #305 from the carrier pin #304.
5. Repeat this process for the two remaining gears in the carrier.
ITEM # QTY PART # DESCRIPTION
301 1 317021 OUTPUT CARRIER
302 3 334218 PLANET GEAR
303 6 518074 THRUST WASHER
304 3 470126 CARRIER PIN
305 3 470036 ROLL PIN 1/4 DIA X 1 1/4 LG
306 204 402136 BEARING-NEEDLE ROLLER
307 3 362315 SPACER
OUTPUT CARRIER
301
303
306
304
302
307
306
303
305