Ramsey Winch 100K WILDCAT WINCH - Manual (Page 5)

CABLE INSTALLATION
1. Unwind cable by rolling it out along the ground to prevent kinking. Securely wrap end of wire
rope, opposite hook, with plastic or similar tape to prevent fraying.
2. Place taped end of cable into hole on drum flange and bend into the track on drum flange.
Secure using supplied u-bolt #73 and (2) nuts.
3. Carefully run the winch in the “reel-in” direction. Keeping tension on end of cable, spool all the
cable onto the cable drum, taking care to form neatly wrapped layers.
4. After installing cable, band brake is used to prevent bird nesting while pulling out cable, when
clutch is disengaged.
73
73
BEND INTO TRACK
AS SHOWN
INSERT END OF CABLE
INTO HOLE AS SHOWN
3 OM-914221-0211-b