Ramsey Winch 100K WILDCAT WINCH - Manual (Page 16)

DISASSEMBLY OF INPUT CARRIER
Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be
purchased individually (see parts list below). If purchasing individual parts, it will be necessary to
disassemble the input gear carrier as outlined below.
1. Carefully drive roll pin #105 into carrier pin #104 so that it is captured within carrier pin #104
but not touching the opposite side of the input carrier #101.
2. Tap carrier pin #104 to remove it from the input carrier #101.
3. Place a plastic pail in a position to catch bearings #103 and washers #106. Then slide the gear
#102 from the carrier #101.
4. Remove the roll pin #105 from the carrier pin #104.
5. Repeat this process for the two remaining gears in the carrier.
106
102
105
103
106
104
101
ITEM QTY PART NO DESCRIPTION
101 1 317018 INPUT CARRIER
102 3 334206 PLANET GEAR
103 102 402135 NEEDLE BEARING
104 3 470111 PLANETARY PIN
105 3 470123 ROLL PIN
106 6 518067 THRUST WASHER
14 OM-914221-0211-b