Ramsey Winch 100K WILDCAT WINCH - Manual (Page 21)

19 OM-914221-0211-b
ASSEMBLY OF OUTPUT CARRIER
Note: Item Numbers refer to Carrier parts list on page 18
1. Place carrier #301 on flat clean surface.
2. Place the gear #302 on a flat thin clean metal plate. Slide the bearings #304 into gear #302.
3. Place thrust washer #308 on top of gear #302. Partially insert planet pin #306 into carrier #301.
4. Insert a thrust washer between gear #302 and carrier #301. Completely insert planet pin #306
into carrier #301 using care to align the roll pin hole in planet pin #306 with the roll pin hole in
the carrier #301.
5. Drive roll pin #305 into carrier #301 until roll pin #305 is ¼” past flush with surface of the carrier
#301.
6. Repeat this process to install the two remaining gears into the carrier.