Ramsey Winch 100K WILDCAT WINCH - Manual (Page 3)

1 OM-914221-0211-b
RAMSEY HYDRAULIC PLANETARY WINCH MODEL WILDCAT 100K
PLEASE READ THIS MANUAL CAREFULLY
This manual contains useful ideas in obtaining the most efficient operation from your Ramsey Winch, and safety
procedures one needs to know before operating a Ramsey Winch. Do not operate this winch until you have carefully
read and understand the "WARNINGS" and "OPERATION" sections of this manual.
WARRANTY INFORMATION
Ramsey Winches are designed and built to exacting specifications. Great care and skill go into every winch we make.
If the need should arise, warranty procedure is outlined on the back of your self-addressed postage paid warranty card.
Please read and fill out the enclosed warranty card and send it to Ramsey Winch Company. If you have any problems
with your winch, please follow instructions for prompt service on all warranty claims. Refer to back page for limited
warranty.
SPECIFICATIONS*
APPROXIMATE WEIGHT: 2200 LBS
WORKING PRESSURE: 2850 PSI
CABLE DIAMETER: 1.125 INCH
MAX FLOW: 60 GPM
LAYER
OF
CABLE
CABLE
CAPACITY
LOW SPEED HIGH SPEED
LINE PULL LINE SPEED LINE PULL LINE SPEED
Ft m Lb Kg fpm mpm Lb Kg fpm mpm
1 50 15 100000 45350 23 6.9 40000 18140 53 16.1
2 110 33 81800 37100 27 8.2 32700 14830 64 19.4
3 180 54 69200 31380 32 9.7 27600 12510 75 22.8
4 265 80 60000 27210 36 10.9 24000 10880 85 25.8
5 360 109 52900 23990 41 12.4 21100 9570 96 29.1
6 465 141 47300 21450 46 13.9 18900 8570 107 32.5
* These specifications are based on recommended wire rope of 1.125” Extra Improved Plow Steel Cable and a
9.0 cu. in. / Rev. motor.
NOTE: The rated line pulls shown are for the winch only. Consult the wire rope manufacturer for wire rope ratings.
WARNINGS:
CLUTCH MUST BE FULLY ENGAGED BEFORE STARTING THE WINCHING OPERATION.
DO NOT START WINCH MOTOR BEFORE ENGAGING CLUTCH.
DO NOT DISENGAGE CLUTCH UNDER LOAD.
STAY OUT FROM UNDER AND AWAY FROM RAISED LOADS.
STAND CLEAR OF CABLE WHILE PULLING. DO NOT TRY TO GUIDE CABLE.
DO NOT EXCEED MAXIMUM LINE PULL RATINGS SHOWN IN TABLE.
DO NOT USE WINCH TO LIFT, SUPPORT, OR OTHERWISE TRANSPORT PEOPLE.
A MINIMUM OF 5 WRAPS OF CABLE AROUND THE DRUM BARREL IS NECESSARY TO HOLD THE LOAD.
CABLE ANCHOR IS NOT DESIGNED TO HOLD LOAD.
BAND BRAKE IS NOT TO BE USED TO HOLD LOAD.