Ramsey Winch 100K WILDCAT WINCH - Manual (Page 18)

DISASSEMBLY OF INTERMEDIATE CARRIER
Carrier assemblies may be purchased as a complete assembly (see pg. 23) or parts may be
purchased individually (see parts list below). If purchasing individual parts, it will be necessary to
disassemble the intermediate gear carrier as outlined below.
1. Carefully drive roll pin #205 into carrier pin #206 so that it is captured within carrier pin #206
but not touching the opposite side of the intermediate carrier #201.
2. Tap carrier pin #206 to remove it from the intermediate carrier #201.
3. Place a plastic pail in a position to catch bearings #204, spacers #203, and washers #207.
Then slide the gear #202 from the carrier #201.
4. Remove the roll pin #205 from the carrier pin #206.
5. Repeat this process for the two remaining gears in the carrier.
201
207
202
205 204
203
204
206
207
ITEM QTY PART NO DESCRIPTION
201 1 317028 INTERMEDIATE CARRIER
202 3 334204 PLANET GEAR
203 3 362307 BEARING SPACER
204 204 402136 NEEDLE BEARING
205 3 470036 ROLL PIN
206 3 470113 PLANETARY PIN
207 6 518067 THRUST WASHER
16 OM-914221-0211-b