IEI Integration iQ7-US15W - Manual (Page 98)

IQ7 Design Guide
Page 86
ƒ Serial Port4 Address [2E8]
Use the Serial Port4 IRQ option to select the interrupt address for serial port 4.
Î
Disabled No base address is assigned to serial port 4
Î
3F8 Serial port 4 I/O port address is 3F8
Î
2F8 Serial port 4 I/O port address is 2F8
Î
3E8 Serial port 4 I/O port address is 3E8
Î
2E8 D EFAULT Serial port 4 I/O port address is 2E8
ƒ Parallel Port Address [378]
Use the Parallel Port Address option to select the parallel port base address.
Î
Disabled No base address is assigned to the Parallel Port
Î
378 D EFAULT Parallel Port I/O port address is 378
Î
278 Parallel Port I/O port address is 278
Î
3BC Parallel Port I/O port address is 3BC
ƒ Parallel Port Mode [Normal]
Use the Parallel Port Mode option to select the mode the parallel port operates in.
Î
Normal D EFAULT The normal parallel port mode is the standard mode
for parallel port operation.
Î
Bi-directional Parallel port outputs are 8-bits long. Inputs are
accomplished by reading 4 of the 8 bits on the
status register.
Î
EPP The parallel port operates in the enhanced parallel
port mode (EPP). The EPP mode supports
bi-directional communication between the system
and the parallel port device and the transmission
rates between the two are much faster than the
Normal mode.