Extron Electronics System 7SC - Manual (Page 37)

3-9 System 7SC • Operation and Configuration
Switcher Setup/Configuration
The flowchart below provides an overview of the Switcher Setup/Configuration
submenu and the options for each setting.
Extron
System 7SC
SWITCHER SETUP/
CONFIGURATION
MENU
NEXT
Scaler output rates
• See the table on the next page for
available combinations of resolutions
and refresh rates.
Default: 640x480, 60 Hz
NOTE Lock = Accu-RATE Frame Lock™
Autoselect the input signal
format for the front panel input
• No
• Yes (default)
RGB input has priority over
S-video & composite video if all
formats are active.
Add Slave
No Slave Swr
NEXT
NEXT
NEXT
Display blue & sync only
• No (default)
• Yes
Autoselect # 07
No (Yes)
NEXT
Add a slave switcher on input 1
• No Slave Swr (default)
...or select a slave switcher input quantity:
• 8 Input Slave
• 10 Input Slave
• 6 Input Slave
• 4 Input Slave
Scaler Blue Out?
(No) Yes
NEXT
RGB Delay
1.5 Sec.
NEXT
Sync formats
• RGBHV (default)
• RGBS
• RGsB Polarity combinations
• H-/V- (default)
• H-/V+
• H+/V-
• H+/V+
Edge Smoothing?
No (Yes)
Smooth edges
• No
• Yes (default) Delay time (in seconds)
• 0.0 (default) up to
• 5.0
in 0.5 sec. increments
Scaler Polarity
H+/V+
Scaler Rate
1280X1024, 60 Hz
NEXT
Scaler Sync
RGsB
NEXT NEXT
Room2 Relay Cnfg
1.375 Sec
NEXT
Configure the Room 2 relay
• Toggle On/Off (default) – Latching mode. The relay
remains open or closed until the button is pressed again.
• X.XXX Sec – Momentary mode. The relay is open or
closed for a set time, adjustable from 0.250 seconds to
2.000 seconds in 0.125 second increments.
Room1 Relay Cnfg
Toggle On/Off
Configure the Room 1 relay
• Toggle On/Off (default) – Latching
mode. The relay remains open or
closed until the button is pressed again.
• X.XXX Sec – Momentary mode. The
relay is open or closed for a set time,
adjustable from 0.250 seconds to 2.000
seconds in 0.125 second increments.
NEXT
Turn 2:2 Pulldown On/Off (per input)
• On – Select this to activate 2:2 film
detection for the selected input to maximize
image detail and sharpness for for PAL
source material that originated from film.
• Off (default) – 2:2 detection is off.
2:2 Pulldown
Input#01 : Off
If you press the Menu button while a submenu is active, the next main menu
will become active. For example, the menu will change from the Switcher
Setup/Configuration menu or submenus to the Audio/Video Adjustments
main menu.
To return to the default screens, let the System 7SC time-out for 8 seconds, or
press the Menu button until the Exit? menu appears, then press the Next button.