ZOLL AED Plus Fully Automatic Rev B - Manual (Page 32)

22 Fully Automatic AED Plus Administrator’s Guide
Maintenance and Troubleshooting
This section describes the following functions to maintain the Fully Automatic AED Plus:
• Maintaining the Fully Automatic AED Plus
• Cleaning the Fully Automatic AED Plus
• Optional Maintenance for Technical Professionals
• Troubleshooting
Maintaining the Fully Automatic AED Plus
• Inspect frequently, as necessary.
• Check for the green check (
)
showing that the Fully Automatic AED Plus is ready to use.
• Verify that electrodes are within their expiration date.
• Verify that batteries are within their expiration date.
• Verify that electrodes are pre-connected to the input connector.
• Verify that supplies are available for use (razor, mask, gloves, extra batteries.)
Maintenance Checklist
Use the following maintenance checklist when you periodically check your Fully Automatic AED Plus.
Table 4: Maintenance Checklist
Cleaning the Fully Automatic AED Plus
• After each use, clean and disinfect the Fully Automatic AED Plus with a soft, damp cloth using
90% isopropyl alcohol, or soap and water, or chlorine bleach and water mixture (30 ml/liter water).
• Do not immerse any part of the Fully Automatic AED Plus in water.
• Do not use ketones (MEK, acetone, etc.) to clean the Fully Automatic AED Plus.
• Avoid using abrasives (e.g., paper towel) on the display window or IrDa port.
• Do not sterilize the Fully Automatic AED Plus.
Check the following Pass Fail
Is the unit clean, undamaged, free of excessive wear?
 
Are there any cracks or loose parts in the housing?
 
Verify electrodes are connected to the Fully Automatic AED Plus and
sealed in their package. Replace if expired.
 
Are all cables free of cracks, cuts and exposed or broken wires?
 
Turn the Fully Automatic AED Plus on and off and verify the green check
indicates ready for use.
 
Batteries within expiration date. Replace if expired.
 
Check for adequate supplies.
 