ZOLL AutoPulse Rev A - Manual (Page 35)

P/N. 12457-001 Rev. 2 Page 7-1
Power System User Guide
7 AutoPulse Multi-Chemistry Battery Charger
Maintenance
Caution: Do not remove the AutoPulse Multi-Chemistry Battery Charger cover. The AutoPulse Multi-
Chemistry Battery Charger has no internal user serviceable parts.
7.1 Cleaning the AutoPulse Multi-Chemistry Battery
Charger
Clean the external surfaces of the AutoPulse Multi-Chemistry Battery Charger at least once a month only
with a lint-free cloth that is either dry or slightly damp with water.
7.2 Replacing a AutoPulse Multi-Chemistry Battery
Charger Fuse
The only user-serviceable parts on the AutoPulse Multi-Chemistry Battery Charger are the alternating
current (AC) power fuses. To check if the fuse has burned out, follow these steps:
1. Unplug the Power Cord from the wall outlet and from the receptacle on the back of the AutoPulse
Multi-Chemistry Battery Charger. Wait one minute before going to step 2.
2. The fuse holder is located directly under the power receptacle on the back of the AutoPulse Multi-
Chemistry Battery Charger (see Figure 7-1). Open the fuse holder by pressing down on the locking
tab and pulling the fuse holder straight out.
Figure 7-1 AutoPulse Multi-Chemistry Battery Charger Fuse Location
Warning: No modification of the AutoPulse Multi-Chemistry Battery Charger, the AutoPulse Li-Ion
Battery, or the AutoPulse NiMH Battery is allowed.
Battery Charger
Fuse Holder