Vanguard DMOM-200 - Manual (Page 26)

Operating Procedures DMOM-200™
20
5.9 Test Record Procedure
This procedure describes the steps to delete
a test record or all test records stored in the
DMOM-200
 Flash EEPROM.
Table 9.0 Erase Test Record Procedure
STEP ACTION DMOM-200  DISPLAY
9-1 On the RESTORE RECORD display (step 7-
2), press key #3 (ERASE RECORD) to
display an ERASE RECORD menu of
options (shown at right).
9-2 On the ERASE RECORD menu display,
press key #1 to erase a single record.
9-3 When this selection is made, the user shall
enter record number then press ENTER key
to confirm. Press ENTER key again to
return to main menu.
NOTE
Press STOP key to abort.
9-4 Press key #2 to erase all records. Press
ENTER key to confirm.
NOTE
Press STOP key to abort.
9-5 Press ENTER key to confirm.
9-6 Press ENTER key to return to main menu.
ERASE RECORD
1.ERASE SINGLE RECORD
2. ERASE ALL RECORDS
ERASE RECORD
NUMBER: XX
RECORD NUMBER: XX
ERASED!
ERASE ALL RECORDS!
Are you SURE?
“ENTER” TO CONTINUE
ERASING RECORDS
PLEASE WAIT
RECORDS ERASED!