Compatible oscilloscope models, Required firmware – Teledyne LeCroy SDA III-CompleteLinQ User Manual
Page 7
Operator's Manual
track, noise spectrum, histogram and Q-fit, and noise measurements broken down into Tn (total noise),
Rn (random noise) and Dn (deterministic noise). The Crosstalk package includes the Crosstalk Eye, which
is an eye diagram based on noise analysis that depicts effects from noise aggressors more clearly than a
standard eye diagram. You can compare Crosstalk Eyes from 2 different lanes.
LaneScape Comparison Mode
When you enable multiple lanes (or one lane + the Reference lane), the oscilloscope automatically turns
on "LaneScape Comparison Mode". In this mode, all waveforms and traces for a single lane are displayed
in its own frame, which you can arrange into different "LaneScapes." You can choose to display one, two
or all LaneScapes at a time to meet your particular needs for comparing analysis results between lanes.
Spectral Rj Direct Jitter Calculation Method
SDAIII-CompleteLinQ includes the Spectral Rj Direct jitter calculation method. This method fixes Rj based
spectral analysis methods, and can return jitter results that compare more closely to results on oscil-
loscopes from other manufacturers. See Understanding SDAIII-CompleteLinQ Jitter Calculation Methods
for more information.
Compatible Oscilloscope Models
The SDAIII-CompleteLinQ family of software options is available on the WavePro/SDA/DDA 7 Zi/Zi-A,
WaveMaster/SDA/DDA 8 Zi/Zi-A, LabMaster 9 Zi-A and LabMaster 10 Zi oscilloscopes platforms.
Required Firmware
Your oscilloscope must be running firmware version 6.9.0.x or higher to support SDAIII-CompleteLinQ
and VirtualProbe. Firmware upgrades are available from
921143 Rev A
5