Teledyne LeCroy QPHY-ENET - Manual (Page 29)

QPHY-ENET Software Option
QPHY-ENET Operator’s Manual Rev G
29
7. Select TP_IDL Tail Mask in the “Select Test” field.
8. Touch the Set Up and Start Test button to begin testing.
9. Install jumpers to test for TPM LOAD2; refer to Table 2 (previous).
10. Select TP_IDL Head Mask in the “Select Test” field.
11. Touch the Set Up and Start Test button to begin testing.
12. Select TP_IDL Tail Mask in the “Select Test” field.
13. Touch the Set Up and Start Test button to begin testing.
14. Install jumpers to test for no TPM LOAD1; refer to Table 2 (previous).
15. Select TP_IDL Head Mask in the “Select Test” field.
16. Touch the Set Up and Start Test button to begin testing.
17. Select TP_IDL Tail Mask in the “Select Test” field.
18. Touch the Set Up and Start Test button to begin testing.
19. Install jumpers to test without TPM LOAD2; refer to Table 2 (previous).
20. Select TP_IDL Head Mask in the “Select Test” field.
21. Touch the Set Up and Start Test button to begin testing.
22. Select TP_IDL Tail Mask in the “Select Test” field.
23. Touch the Set Up and Start Test button to begin testing.
Figure 19. TP_IDL head mask test