Teledyne LeCroy FlexRay Trigger, Decode and Physical Layer Test - Manual (Page 5)

O PERATOR ’ S M ANUAL
The TDP Series Software
The TDP option adds the following capability to the LeCroy oscilloscope software user interface dialogs:
1. Serial Trigger
Selection
If this is the first serial trigger option you
have installed on your scope, an
additional icon appears in your trigger
dialog box. It allows a serial trigger
condition to be set from within the
oscilloscope using an easy-to-
understand interface.
2. Serial Decode If this is the first serial decode option
you have installed on your scope, an
additional set of Serial Decode and
Decode Setup dialog boxes are
provided for setup of protocol format (as
necessary) and decoding. These can be
accessed from the Analysis menu.
3. Decode Protocol
Selections
FlexRay is one of several signal types
that can be decoded by the
oscilloscope. Other standards in I
2 C,
SPI, UART, RS-232, CAN and LIN.
4. Physical Layer Test Eye diagram and physical layer
measurement parameters are accessed
through the Serial Decode setup by
selecting the Physical Layer Tab
FlexRay-TDP-OM-E Rev A
5