Teledyne LeCroy FlexRay Trigger, Decode and Physical Layer Test - Manual (Page 17)

O PERATOR ’ S M ANUAL
Protocol Results Table
The protocol results table provides a quick and easy way to understand all of your FlexRay data as decoded by
the oscilloscope, even when messages are too compacted to allow annotation on the display. In addition, the
table provides a quick and easy method to look at decode results, and quickly zoom to a specific message.
When displayed, the protocol results table appears under the waveform grid.
The slider bar on the right can be used to navigate through the protocol table. If the slider bar is yellow, then you
can use the Adjust knob on the oscilloscope front panel to move the slider bar.
If you touch a row, a decoded zoom trace is created and displays that message trace in a zoom.
The table is only shown if the View Table checkbox is checked and decode has occurred on the trace. Only one
protocol table can be viewed at a time. As described in the preceding section, the protocol table can be
configured or exported. If you press the Configure Table button in the Decode Setup dialog box, a pop-up dialog
similar to the one as follows is shown.
Default – Press the Default button to return to the default state of the table
for that particular protocol.
Checkboxes – If you wish the item to be present as a column in the table
for that particular protocol, touch the item to check the box.
BitRate Tolerance –This can be set to any value from 0.01% to 10%. If
the bit rate is outside the tolerance range set, then the calculated bit rate
appears as red text in the table
FlexRay-TDP-OM-E Rev A
17