Teledyne LeCroy FlexRay Trigger, Decode and Physical Layer Test - Manual (Page 28)

6. Display an individual segment separately from the main channel display by selecting Math Æ Math Setup
from the menu bar. Now, choose a math trace to define as a Segment (here we’re defining F1 as a Segment
of C2).
Use the channel the serial data was acquired on as a source (in this case Channel 2). Check the TRACE ON
checkbox to display the trace. Select a segment to view by touching the Select tab and use either the pop-up
keypad or the front panel adjust knob.
7. Set up the Decode to use
the Math trace as the
source for Data in order to
view decoded data on the
individual segment (in this
case F4 is the source).
To change the decoded
segment, just select a new
segment from the Math
trace dialog (as shown in
the preceding step).
28
FlexRay-TDP-OM-E Rev A