Teledyne LeCroy FlexRay Trigger, Decode and Physical Layer Test User Manual
Page 27
O
PERATOR
’
S
M
ANUAL
FlexRay-TDP-OM-E Rev A
27
2. In
the
Sampling Mode area, select Sequence
Mode. Touch the Sequence tab (now showing next
to the Timebase tab).
3. On the Sequence tab, select the Display Mode.
Select the Number of Segments Displayed at one
time.
4. If you have acquired more segments than you can
display at one time, you can choose which segment
at which to start the display.
5. As described previously in this manual, set up the Serial Trigger to capture the event you desire. For instance,
for instance, you might want to trigger on a specific address or data value, and capture long pre-trigger time to
determine what precedes that message. In this example, we’ve used a simple I
2
C Start trigger. To begin the
sequence mode acquisition, press the front panel SINGLE trigger button. Each time the trigger condition is
met, the TRIG’D light on the front panel flashes. When you’ve acquired the set number of segments, the
trigger STOPS and the following display is shown (this is a 50 segment acquisition in Mosaic display mode).