Teledyne LeCroy FlexRay Trigger, Decode and Physical Layer Test - Manual (Page 14)

Data Selection – This pop-up dialog allows you select the channel
or other source for decoding.
Decode Setup Shortcut Button – This provides quick access to
the second tab (Decode Setup) where there are quick buttons for
Search, and Table (Configure Table and Export Table). If you have
already defined the trigger, then the trigger setup settings copy over
into the decode setup.
Search – Push this button to open a Zoom (Zx trace) that has, as
its source, the corresponding Channel (Cx trace). In addition, the
right hand dialog in the Zoom trace has Search options specific to
the FlexRay protocol.
Decode Setup Dialog Box
The Decode Setup dialog box is where the details of the FlexRay protocol decode are entered. It appears as
follows:
This is a single tab with an indicator on the left side that describes which of the four decoders the setup
information pertains to. The left hand side of this dialog box is described below (the right hand side is described in
the protocol specific chapters):
Decoder # Buttons – This describes which of the four decoders the currently
entered information pertains to.
View Decode Checkbox – Touch this box to check or uncheck whether you
want decoding turned ON. Decoding ON provides a highlight of each
message frame, with color-coded highlighting and decoding of the various
portions of the protocol message. Note that for very long acquisitions with
hundreds or thousands of messages, decoding of the entire acquisition takes
longer.
14
FlexRay-TDP-OM-E Rev A