Teledyne LeCroy ZS4000 - Manual (Page 28)

ZS4000 High-Impedance, Active Probe
22 923360-00 Rev A
Safety Compliance
EC D ECLARATION OF C ONFORMITY
–
L OW V OLTAGE
The probe meets intent of EC Directive 2006/95/EC for Product Safety.
Compliance was demonstrated to the following specifications as listed in the
Official Journal of the European Communities:
EN 61010-1:2010 Safety requirements for electrical equipment for measurement,
control, and laboratory use – Part 1: General requirements
EN 61010-031/A1:2008 Safety requirements for electrical equipment for
measurement, control, and laboratory use – Part 031: Safety requirements for
hand-held probe assemblies for electrical measurement and test.
Environmental Compliance
E ND -O F -L IFE H ANDLING
The probe is marked with this symbol to indicate that it complies
with the applicable European Union requirements to Directives
2002/96/EC and 2006/66/EC on Waste Electrical and Electronic
Equipment (WEEE) and Batteries.
The probe is subject to disposal and recycling regulations that vary by
country and region. Many countries prohibit the disposal of waste
electronic equipment in standard waste receptacles. For more
information about proper disposal and recycling of your Teledyne LeCroy
product, please visit teledynelecroy.com/recycle.
R
ESTRICTION OF
H
AZARDOUS
S
UBSTANCES
(R
O
HS)
The product and its accessories conform to the 2011/65/EU RoHS2 Directive, as it
has been classified as Industrial Monitoring and Control Equipment (per Article 3,
Paragraph 24) and is exempt from RoHS compliance until 22 July 2017 (per Article
4, Paragraph 3).