Teledyne LeCroy WaveMaster 8 Zi_Zi-A - Manual (Page 84)

WaveMaster 8 Zi/Zi-A Oscilloscopes
76 922133-00 Rev A
PLEASE NOTE THE FOLLOWING:

You can tune the dwell time that the oscilloscope waits before
loading the next trigger setup using the Dwell Time data entry
control.

If you have Persistence display mode enabled, all trigger events are
recorded on the display. Refer to the Persistence Setup (on page
82) topic for instructions on enabling Persistence display mode.

If you want TriggerScan to stop when the next oscilloscope trigger,
check the Stop On Trigger checkbox. You can use this to isolate
specific trigger setups.
Saving TriggerScan Setups
You should save TriggerScan setups once you have made any modifications
to the Trigger List. The current Trigger List is not be preserved after exiting
the application unless you save it.
1. On the TriggerScan dialog, touch inside the Setup File Name data
entry control and providing a file name using your preferred input
control method. Additional information on using the touch screen
controls can be found in the Dialog Area (on page 33).
OR
Touch the Browse button and select a location and file name.
2. Touch the Save Setup... button.
Note: You can load previously saved TriggerScan setups by touching the
Browse button, locating the file, and then touching Load Setup....