Teledyne LeCroy WaveMaster 8 Zi_Zi-A - Manual (Page 109)

Getting Started Manual
922133-00 Rev A 101

Using a Corresponding Px Tab/Dialog - After directly accessing a
corresponding Px dialog, touch the Measure control and the Select
Measurement pop-up is shown.
Regardless of how you performed the previously described initial steps, at
this point access your corresponding Px dialog to change other setup items
as follows:
1. Touch inside the Source1 control and select an input waveform from
the Select Source window.
2. Touch inside the Measure field and select a parameter from the
Select Measurement window.
3. Touch the Histogram button at the bottom of the dialog. After
touching this button, the Math selection for Histogram pop-up is
shown. Select the desired Math Trace in which to store the results.
Touch the Close button when you are finished.
Touch the trace descriptor label for the math trace just created for the
results, and then touch the Histogram tab to access its right-hand dialog.
Numbers on the previous image correspond with the following
explanations.