Teledyne LeCroy PXD Series - Manual (Page 11)

901217-01 ISSUED: March 2003
7
INSTALL PXD DEVICE DRIVER
The Installation process is divided into five parts.
I.
Install the PXD Device Drivers onto the controller.
II. Turn Power off and install the PXD Module hardware into the PXI mainframe.
III. Repower and Run the Found New Hardware Wizard.
IV. Install the PXD IVI Application software.
V. Install the PXD IVI Driver. The following section will guide you step by step in this process.
• Run the PxdDeviceDriver.exe file from the PXD Series Driver sub-directory on the CD ROM.
The following dialog box will appear:
• Click No, then turn computer off and install Digitizer hardware.
INSTALL THE PXI DIGITIZERS
• Shut down the instrument and install the Digitizer in the PXI chassis slot by first inserting the
Digitizer’s card edge into the front module guides (top and bottom). Slide the Digitizer to the
rear of the mainframe with the injector/ejector handle pushed down.
• When the Digitizer is securely in place, push up on the injector/ejector handle to fully seat the
Digitizer in the chassis.
• Secure the Digitizer to the front panel of the chassis with the mounting screws.
• Cover any open slots in the PXI chassis to ensure proper air flow.
Note: It is best to install the device driver with the Digitizer already installed in the
chassis.