Superwinch Certus Wireless for Superwinch S Series winches - Manual (Page 4)

4 33
When the receiver is powered on, it will be in program mode for 5 seconds and
the LED on the receiver will blink during this 5 second period. To program a
transmitter, press any 3 buttons on the transmitter within this 5 second period
and when the LED stops blinking, programming of the transmitter is complete.
OPERATION INSTRUCTIONS
Programming the transmitter
Note: Transmitters supplied with the unit are pre-programmed at
the factory.
DO NOT RE-PROGRAM THEM.
Should a new transmitter be purchased it will require programing.
To Program, follow the instructions below:
Low Battery LED
Start Button
Cable in
Button
Stop Button
Cable out
Button
(Fig. 2)
Operation
LED
MANTENIMIENTO
Según la intensidad de uso, las pilas del transmisor deberán cambiarse
después de cierto tiempo.
Instrucciones de programación:
DIAGNÓSTICO DE FALLAS
P ROBLEM P OSSIBLE C AUSES S OLUTIONS
The system does not respond
to the controls
Absence of power in the
receiver unit.
-Check that the emergency mushroom button on
the transmitter is in the release position
-Check that the vehicle battery is correctly
connected to the receiver unit
Incorrect connection of the
cabling to the utilities
-Check the cabling to the users (indicators,
electro-valves etc.)
Incorrect installation of the
receiver
-The receiver must not be shielded by ferrous
masses (see “POSITIONING OF THE
RECEIVER UNIT”)
System not coded
-Re-code the system (see “CODING THE
SYSTEM”)
Check that the harness is correctly connected to the
receiver unit and winch or the solenoid on P/N’s
06716 and 06717.
Re-program the system (see page 4) System not programmed
The receiver must not be shielded by large iron
structures
PROBLEMA CAUSAS POSIBLES SOLUCIONES
El sistema no responde
a los controles
No hay alimentación eléc-
trica en el receptor
.
Instalación incorrecta del
receptor
Sistema no programado
Verificar que el arnés de conductores esté
bien conectado al receptor y el guinche, o la
solenoide de partes N° 06716 y 06717.
El receptor no debe estar bloqueado por
grandes estructuras de acero.
Volver a programar el sistema (véasepágina 4)