Superwinch Certus Wireless for Superwinch S Series winches - Manual (Page 3)

3 34
Misuse or abuse of this equipment could result in injury to the user or others
and/or damage to property.
The control will be brought to a stop if:
1. The red STOP button is pressed
2. The system encounters the same frequency from an outside source.
3. Two minutes pass (system is idle) since the last transmission.
These safety features are engineered into
the system to protect personnel and
equipment and should never be changed,
taken out or bypassed.
If an emergency situation arises immediately
press the red stop button on the transmitter .
see (Fig. 1)
WARNING !
1. Never leave the transmitter unattended.
2. The transmitter is only to be used where there is a clear view of the operating
machinery.
3. Do not use more than one transmitter for one receiver box. If you own or
purchase a backup transmitter it is important to stow the second transmitter
securely. When the system is first put into use, the backup unit should be tested
then have it’s battery removed and the unit should be stored in a secure place
to avoid accidental operation, which may result in serious injury or death.
4. Both the transmitter housing and buttons should be checked on a regular
basis and, if damaged, the transmitter should be taken out of use.
5. The battery level of the transmitter should be checked prior to use. When the
battery is low (2.5V – 2.3V) the red LED will repeatedly flash when either of the
two operation buttons is depressed. At this point it is recommended that the
battery be replaced. When the battery reaches 2.2V, the red LED will stay on
when either of the two operation buttons is depressed. The battery should be
changed, see (Fig. 2).
6. In an emergency situation, the red STOP button should be pressed immediately.
Stop Button
(Fig. 1)
Datos técnicos - Receptor
Datos técnicos - Transmisor
• Cantidad de comandos: 2
• Bandas de frecuencia: ISM 868/915 MHz
• Alimentación: 2 pilas AAA de 1.5 V
• Consumo en estado pasivo ~ 1 uA
• Consumo promedio en transmisión: 14 mA
• 2 LED indicadores
• Teclado de goma siliconada (caja según normas IP67)
• Temperatura de servicio: -40 °F (-200 °C) a +1580 °F (+700 °C)
• Dimensiones: 4.29” (109 mm) x 2.20” (56 mm) x 1.18” (30 mm)
• Cantidad de salidas: 2
• Bandas de frecuencia: ISM 868/915 MHz
• Control electrónico con microprocesador
• Dimensiones (incluyendo la antena): 7.48” (190 mm) x 3.27” (83 mm) x .87”
(22 mm)
• Norma de la caja: IP67
• Protegido contra inversión de polaridad
• Alimentación eléctrica de 12/24 VCC (tolerancia 10 a 30) por medio de la
batería del vehículo
• Corriente típica en estado pasivo -18 mA a 12 V -14 mA a 12 V
• Fusible automático interno con reposición: 7 Amp.
• Corriente máxima por cada canal: 5 Amp.
• Corriente total máxima: 7 Amp.
u