HTP PHR199-55C User Manual
Page 63
63
LP- 325 REV. 3.21.14
49
150
o
F
Tank Min. Set Point*
This parameter sets the minimum temperature inside the storage tank in both cold and warm outdoor temperatures.
Range: 32 – 180
o
F
Table 13
* The Differential on the Tank Min. Set Point is a fixed 7
o
F on Versa-Flame Models. The Differential Set Point on Pioneer Models is
variable based on the |dh| setting (also used for indirect differential).
Central Heating Curve Function
Central heating demand is detected when the room thermostat closes. When an outside sensor is also connected, the supply
temperature will depend on the factory default central heating curve.
To set your heat curve, you will have to set the following parameters:
1. Minimum outside design temperature: Function 8.
Table 15
– Central Heating Curve – Factory Default
2. Design supply water temperature at the minimum design outside temperature: Function 9.
3. Maximum outside design temperature: Function 10.
4. Design supply water temperature at the maximum outside temperature: Function 11.
NOTE: Versa-Flame minimum set point Function 49 may override the supply temperature for Function 11.
NOTE: The homeowner can adjust the heat curve down by adjusting the central heating and/or DHW temperature to a lower setting.
CONTROL PROGRAM REFERENCE CHART
FUNCTION
DEFAULT
SETTING
PROGRAMMED
SETTING
1
de
No change allowed
2
149
o
F
No change allowed
3
160
o
F
4
36
o
F
No change allowed
5
7
o
F
6
0 Min.
7
68
o
F
8
5
o
F
9
180
o
F
10
68
o
F
11
95
o
F
12
68
o
F
13
0 Min.
14
30 Min.
15
0
16
0
17
0
18
1
19
185
o
F
20
3
N/A
21
0
22
100%
23
0
24
24 hrs.
25
0
26
---
27
0
28
0
29
0
30
0
31
N/A
Table 14