HTP PHR199-55C - Manual (Page 46)

46
LP- 325 REV. 3.21.14
PART 6 – FIELD WIRING
ELECTRICAL SHOCK HAZARD – For your safety, turn off electrical power supply at service entrance panel before making any
electrical connections to avoid possible electric shock hazard. Failure to do so can cause severe personal injury or death.
Label all wires prior to disconnecting them when servicing the appliance. Wiring errors can cause improper and dangerous operation.
Failure to follow these instructions may result in property damage or personal injury.
Wiring must be N.E.C. Class 1. If original wiring supplied with the appliance must be replaced, use only TEW 105
o
C wire or equivalent.
Appliance must be electrically grounded as required by National Electrical Code ANSI/NFPA 70 – Latest Edition.
A. INSTALLATION MUST COMPLY WITH:
1. National Electrical Code and any other national, state, provincial, or local codes or regulations.
2. In Canada, CSA C22.1 Canadian Electrical Code Part 1, and any local codes.
To avoid electrical shock, turn off all power to the appliance prior to opening an electrical box within the unit. Ensure the power remains
off while any wiring connections are being made. Failure to follow these instructions could result in component or product failure,
serious injury, or death. Such product failure IS NOT covered by warranty.