Gilderfluke&Co DMX-512, Serial, and MIDI Output Smart Bricks User Manual
Page 30
-Gilderfluke & Company - Serial Output Smart Brick - v1.05 - copyright 1999 DCM-
EPROM: 123 channels @ 30 FPS / first show is 12345 frames long
Card Channel | Card Channel
0) ___ 1) ___
2) ___ 3) ___
4) ___ 5) ___
6) ___ 7) ___
8) ___ 9) ___
a) _12 b) ___
c) _13 d) ___
e) _14 f) ___
g) _15 h) ___
i) _16 j) ___
k) _17 l) ___
m) _18 n) ___
o) _19 p) ___
q) ___ r) ___
s) ___ t) ___
u) ___ v) ___
w) ___ x) ___
y) ___ z) ___
enter number of string to edit, or
k)
Analog Resolution: This is a Rexroth Mode specific command. This command is used to toggle
between eight, twelve and sixteen bit resolution analog values to be sent to the Rexroth
DCCs. The resolution does not affect the time it takes to send messages to the DCCs. You will
need to make sure that when you save the Eprom file from PC¥MACs and set the Eprom offset
(command ÔaÕ above) that enough channels are saved.
l)
String Trigger Channel: This command is used to set the address of the eight bit channel that
is used to trigger the strings which are entered using the next command. Setting this value to
255/0FFh will disable this feature.
Any eight bit channel of animation data can be used to trigger the sending of the strings
which are entered using the next command. There are a total of sixteen strings available.
Each bit triggers one string to be sent on the rising edge, and a second completely different
string on the falling edge. This feature is typically used to send strings that need to be sent too
regularly for using the ÔMonitor ChannelÕ feature.
m) Edit Strings.....: This command brings up the following menu. It is used to enter the strings that
are sent when using the ÔString TriggerÕ feature. There are sixteen possible strings. Each string
can be up to eighteen characters long. One is sent on the rising, and a different one is sent
on the falling edge of each of the eight bits in the String Trigger channel.
G
ILDERFLUKE
& C
O
.¥ 205 S. F
LOWER
S
T
. ¥ B
URBANK
, CA 91502 ¥ 818/840-9484 ¥ 800/776-5972 ¥
FAX
818/840-9485
30 of 48