Gilderfluke&Co Sd-25 Audio Repeaters w/Amplifier - Manual (Page 8)

(SoundFiles 1 through ??) as long as the input stays
active.
Option #8: DipSwitch #8: Randomizer. When on,
SoundFiles are played in random order, rather than
sequentially.
Option #9: DipSwitch #9: Unsteppable. When on,
additional start commands to the Sd-25 will be ig-
nored until the currently playing triggered SoundFile
has completed.
Mode B / on/on/off/on/off
Like Mode A, except the ʻbʼ input plays SoundFiles 2
through ?? instead of ʻAllʼ the SoundFiles.
Options:
Option #2: The one SoundFile that is selected will
loop as long as the input stays active (only on Firm-
ware version 1.16 or later): unless DipSwitch #6 or
DipSwitch #7 are on.
Option #6: DipSwitch #6: (Firmware version 1.16
or later) When on, the SoundFile will only play once
(no looping).
Option #7: DipSwitch #7: (Firmware version 1.16
or later) When on, input ʻaʼ will loop SoundFile #1 as
long as the input stays active, and input ʻbʼ will loop
through SoundFiles 2 through ?? as long as the in-
put stays active.
Option #8: DipSwitch #8: Randomizer. When on,
SoundFiles are played in random order, rather than
sequentially.
Option #9: DipSwitch #9: Unsteppable. When on,
additional start commands to the Sd-25 will be ig-
nored until the currently playing triggered SoundFile
has completed.
Mode C / off/off/on/on/off
Single trigger with reshuffle
Input ʻaʼ plays ALL of the SoundFiles on the Sd-25
(SoundFiles 1 through ??). Input ʻbʼ reshuffles the
ʻPlayListʼ triggered by the ʻaʼ input.
Options:
Option #2: The one SoundFile that is selected will
loop as long as the input stays active (only on Firm-
ware version 1.16 or later): unless DipSwitch #6 or
DipSwitch #7 are on.
Option #6: DipSwitch #6: (Firmware version 1.16
or later) When on, the SoundFile will only play once
(no looping).
Option #7: DipSwitch #7: (Firmware version 1.16
or later) When on, input ʻaʼ will loop through Sound-
Files 1 through ?? as long as the input stays active.
Option #8: DipSwitch #8: Randomizer. When on,
SoundFiles are played in random order, rather than
sequentially.
Option #9: DipSwitch #9: Unsteppable. When on,
additional start commands to the Sd-25 will be ig-
nored until the currently playing triggered SoundFile
has completed.
Mode D / on/off/on/on/off
Single trigger with mute on ʻaʼ
Fade to -6dB on ʻbʼ
Mode E / off/on/on/on/off
Single trigger with mute on ʻaʼ
Fade to -12dB on ʻbʼ
Mode F / on/on/on/on/off
Single trigger with mute on ʻaʼ
Fade to -24dB on ʻbʼ
Mode 10 / off/off/off/off/on
Single trigger with mute on ʻaʼ
Fade to muted on ʻbʼ
Input ʻaʼ plays ALL of the SoundFiles on the Sd-25
(SoundFiles 1 through ??) on each successive but-
ton press. Firmware versions before v1.27 will loop
a single SoundFile on sustained ʻaʼ input closures.
Firmware versions after v1.27 will loop through ALL
the SoundFiles on the Sd card on sustained ʻaʼ input
closures.
Input ʻbʼ ramps the audio down -6dB from full vol-
ume. The only difference among the next three
modes is the ʻmutedʼ volume level the ʻbʼ input se-
lects.
Options:
Option #1: DipSwitches #6 and #7 are used to se-
lect the speed at which the audio ramps in/out.
Option #8: DipSwitch #8: Randomizer. When on,
SoundFiles are played in random order, rather than
sequentially.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
page 8 of 16 • © February 11, 2014 Gilderfluke & Co. DCM