Mode 1d / on/off/on/on/on, Mode 1e / off/on/on/on/on – Gilderfluke&Co Sd-25 Audio Repeaters w/Amplifier User Manual

Page 12

ware version 1.16 or later): unless DipSwitch #6 or
DipSwitch #7 are on.

Option #6: DipSwitch #6: When on, the SoundFile
will only play once (no looping).

Option #7: DipSwitch #7: When on, input ʻaʼ will
loop through SoundFiles 1 through ?? as long as the
input stays active. Short pulses on the ʻaʼ input tend
to play sequentially, even if DipSwitch #8 is on.
Option #8: DipSwitch #8: Randomizer. When on,
SoundFiles are played in random order, rather than
sequentially. Unlike most other modes where the
SoundFiles are played randomly, this mode does
not check to see whether the same SoundFile has
been played recently. This means that it is possible
for the same SoundFile to be played twice in a row.

Mode 1d / on/off/on/on/on

Fade out and Trigger Two PlayLists, with looping
background SoundFile

This mode requires Sd-25 Firmware v1.17 or later.
Like Mode 17, except it fades out the SoundFile that
is playing to the level set by DipSwitches #6 and
#7 BEFORE starting the newly triggered SoundFile
at the ʻnormalʼ playback volume. At the end of the
triggered sound, the background SoundFile will be
restarted at the ʻramped downʼ volume level, then
fade back up to the ʻnormalʼ audio playback level.

This mode divides all of the SoundFiles into two
evenly sized ʻPlayListsʼ. Input ʻaʼ triggers SoundFiles
from the first half, and input ʻbʼ triggers SoundFiles
from the second half.

There must be at least three SoundFiles on the Sd-
25 for this mode. If there is an even number of
SoundFiles on the Sd-25, then the first PlayList
(triggered by the ʻaʼ input) will have one more
SoundFile than the second PlayList (triggered by ʻbʼ
input).
The Sd-25 will loop the last SoundFile on the card
whenever it isnʼt playing a triggered SoundFile. The
background looping SoundFile will start playing as
soon as the Sd-25 is powered up. Even if the ʻno
stepʼ switch is ʻonʼ (DipSwitch #9), the background
SoundFile can be stepped upon by a trigger to play
a SoundFile from the ʻaʼ or ʻbʼ inputs. The Sd-25ʼs
ʻstatusʼ output only goes active when it is playing a
triggered SoundFile.

If both the ʻaʼ and ʻbʼ inputs are held simultaneously,
the audio will fade out to the level set by
DipSwitches #6 and #7 and stay there until at least
one of the inputs is released.
A ʻshortʼ pulse (more than 1/8 second, but less than
1/4 second) on the ʻaʼ or ʻbʼ (or both) inputs ʻreshuf-
flesʼ the ʻPlayListsʼ.

The one triggered SoundFile that is selected will
only play once (no looping).

The fade rate is fixed in this mode to the ʻslowestʼ
possible speed.

Options:

Option #3: The fade level (fully muted, -9 dB, -18
dB or -33 dB) is selected using DipSwitches #6
and #7.

Option #8: DipSwitch #8: Randomizer. When on,
SoundFiles are played in random order, rather than
sequentially.

Option #9: DipSwitch #9: Unsteppable. When this
switch is ʻoffʼ, if the ʻaʼ or ʻbʼ trigger input is pressed,
then released before the triggered SoundFile has
played, the audio will simply ramp back up to the
normal level. When this switch is ʻonʼ, then even a
short press of the ʻaʼ or ʻbʼ trigger input will ramp the
background sound and play the triggered sound, re-
start the background sound and ramp the volume
back up to the ʻnormalʼ audio playback level. A sec-
ond trigger will not be accepted until after the trig-
gered sound has played. Reshuffles are disabled
when this switch is ʻonʼ.

Mode 1E / off/on/on/on/on

Fade out and Trigger SoundFiles one or two, with a
background SoundFile PlayList.

This mode requires Sd-25 Firmware v1.17 or later.
Like Mode 18, except it fades out the SoundFile that
is playing to the level set by DipSwitches #6 and
#7 BEFORE starting the newly triggered SoundFile.

Input ʻaʼ plays the first SoundFile on the Sd/MMC
Flash card. Input ʻbʼ plays the second SoundFile on
the Sd/MMC Flash card. If not playing either of
these SoundFiles, then SoundFiles 3 through ?? will
be played. If the ʻRandomʼ switch (DipSwitch #8) is
ʻonʼ, the background SoundFiles will be played in a
Random order. Even if the ʻno stepʼ switch is ʻonʼ

Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485