SKC Limited AirChek 3000 Deluxe Pump Operating Instructions - Manual (Page 38)

Page 36 210-3311M Issue E www.skcltd.com
User Interface Level Two
6) Deleting a Delayed Start Time or DataTrac Program
The following procedure is used to delete a delayed start time setting. If a DataTrac sampling program has
been entered into the pump memory using the optional DataTrac Interface and Software and a PC, the same
procedure is used to delete the DataTrac program from the pump memory.
1. Enter User Interface Level Two as detailed in Getting Started 7) on page 19.
2. Press the button until the flashing ‘Off’ screen is displayed.
Note: This screen is only displayed if a delayed start time is set or a DataTrac
program is present in the pump memory.
3. To delete the sample run time or DataTrac program press [ ]. The 12/24 hour
clock setting screen will be displayed.
4. Press the button until the ‘End’ screen is displayed.
5. Press [ ] to save the setting and switch to HOLD mode. The ‘PROG’ icon will
no longer be displayed on the run time data screens.