SKC Limited AirChek 3000 Deluxe Pump Operating Instructions - Manual (Page 34)

Page 32 210-3311M Issue E www.skcltd.com
4. To save the new sample run time setting, press the button until the ‘End’
screen is displayed. Press [ ] to save the setting and switch to HOLD mode.
5. Alternatively to exit the User Interface without saving the changes, press the
button until the ‘ESC’ screen is displayed. Press [ ] to switch to HOLD mode
without saving the changes.
6. Having successfully saved a sample run time and switched to HOLD mode, the
elapsed run time screen will show a flashing ‘S’ and the programmed sample run
time in minutes.
7. Press [ ] to switch to RUN mode and start the sampling operation. The
sample run time will count down in one minute steps.
8. At the end of the sample run time the pump will automatically switch to HOLD
mode, and the display will revert to showing the set sample run time.
Note:
• After cancelling a previously set sample run time, the elapsed run time screen will display the total sample
run time since the run time data was last reset.
• If a sample run time has been set on the pump, a DataTrac program cannot be entered into the pump
User Interface Level Two