SKC Limited AirChek 3000 Deluxe Pump Operating Instructions - Manual (Page 33)

www.skcltd.com 210-3311M Issue E Page 31
User Interface Level Two
6. Press the button once and the clock time minutes value will start to flash. Use
the and buttons to enter the correct clock minutes.
7. To save the new clock settings, press the button until the ‘End’ screen is
displayed. Press [ ] to save the settings and switch to HOLD mode.
8. Alternatively to exit the User Interface without saving the changes, press the
button until the ‘ESC’ screen is displayed. Press [ ] to switch to HOLD mode
without saving the changes.
3) Setting a Sample Run Time
1. On the pump enter User Interface Level Two as detailed in Getting Started 7) on page 19.
2. Press the button until the sample run time setting screen is displayed with the
currently set sample run time flashing. The run time is displayed in minutes.
3. Use the and buttons to enter the required sample run time in minutes. The
sample run time can be set to any value between 1 and 999 minutes, for example
480 minutes (8 hours) as shown.