SecurityMan DigiairWatch Series User Manual

Page 32

• • Adding Cameras

To add a camera to your system, simply highlight any of the
available cameras/channels (unlocked) and press the

OK button

on the receiver. Once selected, a confirmation screen will pop
up asking you to confirm (

YES) or cancel (NO) your selection,

use the

LF and RT buttons to make your selection and press the

OK button to confirm. During the registration process a pop up
window showing “

Add/Remove Camera” will be displayed for

approximately 10 seconds. At this time press the pairing button
located on the back of the camera a few times until you get a
confirmation stating that “pairing was successful”.
NOTE: When adding a camera, the pair button located on the
back of the camera must be consecutively after pressing the
OK button on the DVR/Receiver. There is a 10 second grace
period for adding cameras, if pairing is unsuccessful before the
10 second grace period has expired than a pop up displaying
“

operation failed” will appear. Pairing must be done within 20 ft

from the receiver.