SecurityMan DigiairWatch Series User Manual

Page 18

IMPORTANT NOTICE: Exiting from quad view to single channel full screen
(while recording) will halt all recording for all cameras except for the live
camera being displayed.

• In

Single Channel Full Screen Display you can use the Camera button on

the receiver to toggle through all four cameras (when applicable) in full
screen display and then press the

Record button to start recording when

the desired camera is being displayed on the screen.

NOTE: Recording in a single camera independently will lock the DVR to
that channel preventing it from being able to toggle to any of the other
available cameras.

Camera button
The

Camera button is used to toggle back and forth between each camera

in full screen display. In Quad mode, you can press the

Camera button

to start and stop recording by highlighting the camera and pressing the
Record button.

Quad Screen button
Pressing the

Quad Screen button will toggle between single channel full

screen display and a split screen of all the cameras on your system.
NOTE: Audio will not be heard or recorded while in quad screen.

Menu button
Press the

Menu button to access the DVR setup menu. The Menu consists

of system Settings, Playback/SD Card, Camera, and Exit. See detail

Menu

Setup operation below.

Exit button
Press the

Exit button at any time to exit out of the menu. The Exit button

plays no role in live display screen.

UP, DOWN, LF, RT buttons
Use the

Up (increase) and Down (decrease) buttons on the DVR/Receiver

at any time during live view to adjust the volume level. The

LF and RT

buttons plays no role in live display screen.