SecurityMan DigiairWatch Series User Manual

Page 28

At this point you can now highlight and select the photo that you
would like to view. While viewing an image use the

LF and RT buttons

to skip or go back to the next/ previous file, press the

Record button

to enable/disable a 3 seconds slide show and auto loop through the
picture files, and press the

OK or Exit button to exit to Photos folder.

TIP: File naming convention: hr-min-sec-Camera#.jpg. It is our
recommendation to install the camera 15~20 ft from the intended
monitoring object and to set motion detection to “Low” for best timely
picture capture in

Photos mode.

• PC Playback

You can playback recorded files on the system when connected to a TV
or monitor as illustrated above or directly from the SD card by inserting
the card into your computers card reader. To playback recorded video
on a PC:

1. Unmount and remove the SD card from the wireless receiver by
gently pushing on the SD card allowing it to pop out from its slot.
2. Insert the SD card into an SD card reader (not included)
connected to your PC (your PC should load the SD card as a new
Removable Drive).
3. When prompted, select the “Open folder to view files” option to view its
contents (you should see two folders labeled

Photos and Videos).

Video: Open the Videos folder and then open one of the Date folders
(

mm-dd-yyyy) to view a list of all recorded events for that date. Once

inside the dated folder there is another sub-folders separated by the
hour. Select the hour you want to playback to get to the time file name
mp4 files. Double-click any of the recorded mp4 files (hr-min-sec-
Camera #.mp4) and the video will begin playing in your default mp4
media player.