SecurityMan DigiAir-SD - Manual (Page 13)

6. A window boot up screen will display as shown below, and then to the main user’s interface.
7. Enable the intercom feature by pressing the Talk button. Sound is transferred from the receiver to
the camera by pressing and holding the Talk button and speaking into the Mic (located on the front
of the receiver); Release the Talk button to listen to the sound from the camera as illustrated below.
Use the UP and DOWN buttons to control the volume of the receiver and camera.
Note: To avoid noise (when using 2-way audio conference) distortion between the digital
wireless camera and wireless receiver, please set the camera farther apart from the receiver,
about 10~15ft away from one another.
8. In real-time monitoring mode with multiple cameras, press the Cam button to manually switch
between cameras, or press the Quad button to view a split screen of all cameras simultaneously.
9. Manual recording: Press the REC button to start the recording and the blue RECORD
indicator LED will light up to indicate the receiver is in record mode. Press the REC button again to
stop the recording and automatically save the manually recorded file. The blue RECORD indicator
LED light turns off to indicate the recording is turned off.
Note: Manual recording can only be operable when the live display screen is in Single full screen
view, hence, it will not be operable when the display is in QUAD view. This recorder can only
record 1 camera at a time, it does not have the ability to record multiple channel or QUAD screen.
10. Motion detection: In live view, press the OK button to activate motion detection recording, and
the motion icon will appear in the center above the main display screen. The motion LED
Detect indicator light on the receiver will turn solid blue to indicate motion detection mode is
active. When motion is detected the receiver will:
10