Rivers Edge RE602 JOURNEYMAN - Manual (Page 41)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 41
Operator's Manual
Rivers Edge One-Man Ladder Stands
14. Insert the backrest spacer (410119) into holes provided on
backrest mounts. This must be done prior to any tightening of
bolts. SEE fIGuRE 10. You must now tighten all nut & bolt
assemblies. Be sure not to over tighten or crush tubing when
tightening!
15. Sections are assembled on the ground in the following order; bot-
tom section (410066 3-step ladder); second section (410068 3-step
ladder with stabilizer bar mount); third section (410069 3-step
ladder w/ mounting holes); top section (assembled top platform
section). SEE fINIShED 17’ JuMBO JACk lADDER.
16. With all sections assembled together on ground, secure all sec-
tions together using (6) provided spring lock pins. Handle of
spring lock pin must be put to the outside of ladder side rails. SEE
fIGuRE 11.
17. Attach the (2) support braces (410024) to the inside of platform
support rails and outside of top ladder section w/ mounting holes
using (4) provided 1/4-20 x 1-1/2” bolts and locknuts. SEE fIGuRE
12. Tighten securely. Be sure not to over tighten or crush tub-
ing when tightening!
18. a. Attach the removable shooting rail by setting rail down over
studs provided on armrests SEE fIGuRE 13. lubrication is rec-
ommended to prevent binding and noise.
b. Attach the (2) provided 9” and (1) provided 54” camo foam pads
to the armrests and shooting rail by wrapping around tubing and
attaching Velcro together.
c. Attach foam-padded seat bumpers (48102) to bottom side of
front seat spacer weldment. Surface must be clean and at room
temperature for proper adhesion.
Figure 13
Figure 11
Figure 12
spring lock pins
support braces
1/4-20 x
1-1/2" bolts
shooting
rail
locknuts