Rivers Edge RE602 JOURNEYMAN - Manual (Page 40)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 40
Operator's Manual
Rivers Edge One-Man Ladder Stands
9. Remove the locknuts from the (2) 1/4-20 x 2-1/4” bolts that were
previously attached to the rear of the seat assembly. Continue by
attaching the assembled seat assembly to the ladder side rails us-
ing (2) provided 1/4-20 x 2-1/4” bolts, locknuts and nylon washers.
SEE fIGuRE 7. Make sure all (4) angle brackets are fully cradling
fabric rails.
10. Insert the shooting rail J-pipes (410113) into the shooting rail front
(410093) and secure together using (2) provided 1/4-20 x 1-1/4”
bolts and locknuts. SEE fIGuRE 8.
11. Insert the two side rails into the flared rails (410089). Secure using
(2) provided 1/4-20 x 1-1/2” bolts, locknuts and steel washers. SEE
fIGuRE 9.
12. Attach the bolt-on ladder step (410034) to the front side of flared
rails using (2) provided 1/4-20 x 2-1/4” bolts, locknuts and steel
washers. SEE fIGuRE 9.
13. Attach the mesh backrest (360012) and the (2) retaining bars
(410081) to the backrest mounts using (6) provided 1/4-20 x 1-1/2”
bolts and locknuts. SEE fIGuRE 10. The mesh backrest must wrap
around the front side of backrest mounts and the plastic stiffening
rod located in the sewn sleeve on each side of the backrest MUST
be positioned behind the backrest retainer bars to act as a stop
and prevent the backrest from pulling out during use. All bolts
MUST go through the backrest retainer bars, the holes provided in
the backrest and the backrest mounts. SEE fIGuRE 10.
Figure 7
seat assembly
1/4-20 x 2-1/4" bolts
Figure 8
Figure 9
Figure 10
1/4-20 x
2-1/4" bolt
bolt-on
ladder step
flared rails
mesh backrest
retaining bars
1/4-20 x
1-1/2" bolts
backrest spacer
locknuts
nylon washers
steel washers
locknuts
locknuts
1/4-20 x 1-1/4"
bolts
shooting rail J-pipes
shooting rail
1/4-20 x 1-1/2"
bolts
locknuts
plastic stiffening
rods