Rivers Edge RE602 JOURNEYMAN User Manual
Page 39
Check for parts online at
www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5
39
Operator's Manual
Rivers Edge One-Man Ladder Stands
6. Attach the tree blade (410090) to the ladder side rails using (4)
provided 1/4-20 x 2-1/4” bolts, locknuts and steel washers. SEE
fIGuRE 4.
7. Attach footrest (410092) to ladder side rails using (2) provided 1/4-
20 x 2-1/4” bolts, locknuts, steel washers and nylon washers. SEE
fIGuRE 5.
8. a. Position the pre-assembled mesh seat/fabric rail mounts (360019)
upside down on a sturdy, hard surface. Spread the rear of fabric rail
mounts apart and insert the rear seat spacer weldment (410122). Tem-
porarily insert (2) 1/4-20 x 2-1/4” bolts and locknuts. SEE fIGuRE 6a.
notE: locknuts will need to be removed in order to attach fin-
ished seat to treestand later in assembly instructions.
b. Spread the front (bent end) of fabric rail mounts apart. With the front
seat spacer weldment (410112) orientated so the angle brackets are
directly up and down, insert (2) provided 1/4-20 x 1-1/4” bolts and
temporarily attach locknuts SEE fIGuRE 6b and 6c. With the front
seat spacer weldment (410112) orientated vertically (SEE fIGuRE
6c), continue by rotating the front seat spacer downward into locking
position so the angle bracket on each side is fully cradling the fabric
rail mounts. SEE fIGuRE 6d. Be sure the front seat spacer locks into
place. This rotating action is a tight fit by design in order to apply the
correct amount of tension on the mesh seat. The use of a rubber mallet
is recommended to force the front seat spacer into position. You must
now securely tighten the (2) 1/4-20 x 1-1/4” bolts and locknuts.
Figure 4
Figure 5
tree blade
1/4-20 x
2-1/4" bolts
locknuts
steel washers
ladder side rails
1/4-20 x 2-1/4" bolts
footrest
locknuts
nylon
washers
Figure 6a
Figure 6b
Figure 6c
Figure 6d
angle brackets
vertically
locknuts
1/4-20 x
1-1/4" bolts
rear seat spacer weldment
fabric rail mounts
1/4-20 x 2-1/4" bolts
locknuts
front seat spacer weldment
front seat spacer
weldment
roate front seat spacer
weldment downward to
tighten seat fabric