Rivers Edge RE602 JOURNEYMAN - Manual (Page 31)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 31
Operator's Manual
Rivers Edge One-Man Ladder Stands
spring lock pins
ASSEMBlY INSTRuCTIONS (RE627)
Tools needed – two 7/16” wrenches, rubber mallet
IMPoRtant assEMBlY tIP: do not tighten any nut and bolt combinations
completely until all parts are assembled together! Finger tighten plus one
turn of a wrench only! this will temporarily hold the lock nut on the bolt while
helping alignment of all parts! after all parts are assembled together, all nut
& bolt combinations must be completely tightened.
1. Attach the front platform (410050) and the rear platform (410058)
together using (2) provided 1/4-20 x 2” bolts, locknuts and steel
washers. SEE fIGuRE 1. DO NOT tighten all nut and bolt assem-
blies completely!
notE: Mesh surface of foot platforms should be on top.
2. Attach the platform support rails (410055) to the bottom of as-
sembled foot platforms using (8) provided 1/4-20 x 2-1/4” bolts,
locknuts and steel washers. SEE fIGuRE 2.
3. Attach the platform flat support braces (1ML40) to the rear plat-
form and platform support rails using (4) provided 1/4-20 x 1-1/2”
bolts and locknuts. SEE fIGuRE 2.
4. Attach the front of the ladder side rails (410053) to the front plat-
form using (2) provided 1/4-20 x 2” bolts (2), locknuts (4) and steel
washers. SEE fIGuRE 3.
5. Attach the left armrest (410062L), right armrest (410062R) and (2)
backrest mounts (410082) to the previously assembled ladder side
rails and platform support rails using (2) provided 1/4-20 x 2” bolts,
(4) 1/4-20 x 2-1/4” bolts, (2) 1/4-20 x 3” bolts, (8) locknuts and (8)
steel washers. SEE fIGuRE 3.
Figure 1
Figure 2
front platform
rear platform
1/4-20 x 2" bolt
steel washers
locknuts
rear platform
platform support rail
Figure 3
ladder side rails
steel washers
1/4-20 x 2" bolt
locknuts
right
armrest
flat support
braces
1/4-20 x 2-1/4" bolts
steel
washers
locknuts
1/4-20 x
1-1/2" bolts
backrest mounts
1/4-20 x 3" bolts
left
armrest
1/4-20 x
2-1/4" bolts
1/4-20 x 2"
bolts