Rivers Edge RE602 JOURNEYMAN - Manual (Page 12)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 12
Operator's Manual
Rivers Edge One-Man Ladder Stands
7. a. Attach the shooting rail (112ML21) by setting rail down over rail studs. SEE
fIGuRE 4. lubrication is recommended to prevent binding and noise.
b. Attach the (2) provided 9" and (1) 24" camo foam pads to the armrests
and shooting rail by wrapping around tubing and attaching Velcro together.
8. Attach the removable seat cushion (48016) to the top of seat frame. Wrap
the velcro seat straps or buckle straps around seat frame and secure
together. Snap the side release buckles together for buckle style seats. Pull
straps tight so seat is not loose.
9. Sections are assembled on the ground in the following order: bottom
section (SL44 ladder); second section (SL43 ladder); third section (SL60
ladder); fourth section (112ML61 flared rails with foot platform attached);
top section (assembled top sitting section). SEE fINIShED 16' fOREMAN
Xl EXTREME lADDER.
10. With all sections assembled together on ground, secure all sections together
using (8) provided spring lock pins. Handle of spring lock pin must be put
to the outside of ladder side rails. SEE fIGuRE 4.
Figure 4
seat cushion
9" camo sleeves
24" camo sleeve
shooting rail
shooting rail mounts
spring lock pins
Figure 6
Figure 5
stabilizer bar
spring lock pins
stabilizer bar extension tube
11. a. Attach the stabilizer bar extension tube (1ML23) to the second ladder
section mounting bracket using (1) provided spring lock pin. SEE fIGuRE
5.
b. Slide the stabilizer bar (L17) into the extension tube and attach the two
pieces together using (1) provided spring lock pin. Spring lock pin must go
through both the extension tube and the stabilizer bar at appropriate hole
to achieve desired distance from tree. Adjustment in length may be needed
when ladder is uprighted later in instructions. SEE fIGuRE 5.
12. a. Tie one end of the provided 9’ rope to the link welded onto the
stabilizer bar, just in front of the tree hugger. Be sure your double knot
is secure. SEE fIGuRE 6.
b. Tie one end of each of the provided 15’ ropes to the tree blade extension
tubes, just in front of the bolt-on tree blade. Be sure your double knots
are secure. SEE fIGuRE 6.
WARNING
fOOT PlATfORM AND SITTING SECTION MuST AlWAYS
fACE ThE SAME DIRECTION, TOWARDS ThE TREE.