Rivers Edge RE602 JOURNEYMAN - Manual (Page 19)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 19
Operator's Manual
Rivers Edge One-Man Ladder Stands
ASSEMBlY INSTRuCTIONS (RE622)
Tools needed – two 7/16" wrenches
IMPoRtant assEMBlY tIP: do not tIGHtEn nut& Bolt coMBInatIons
coMPlEtElY untIl all PaRts aRE assEMBlEd toGEtHER! FInGER tIGHt-
En Plus onE tuRn oF a WREncH onlY! tHIs WIll tEMPoRaRIlY Hold tHE
lock nut on tHE Bolt WHIlE HElPInG alIGnMEnt oF all PaRts! aFtER
all PaRts aRE assEMBlEd toGEtHER, all nut & Bolt coMBInaItons
Must BE coMPlEtElY tIGHtEnEd.
1. Attach the foot platform (1ML61), mesh side up, to the 2-step ladder section
w/ stabilizer bar mount (SL64) using (2) provided 1/4-20 x 2-1/4” bolts and
locknuts. SEE fIGuRE 1. DO NOT tighten all nut & bolt assemblies
completely!
notE: Mesh surface should be on top with squared ends of platform
closest to ladder.
2. Attach the foot platform flat bars (AL7) to the foot platform and to the inside
of top ladder section side rails using (4) provided 1/4-20 x 1-1/2” bolts and
locknuts. SEE fIGuRE 1.
3. Attach sling seat (48066) to assembled top sitting section by sliding each
side rail through webbing loops of seat (3 on each side of seat). Seat should
be orientated with seat straps on bottom side of seat for comfort.
notE: always have all three seat loops on each side of seat at-
tached to the side rails of assembled top sitting section.
4. Attach the tree blade frame (SL67) to the side rails (SL69) using (4) provided
1/4-20 x 2-1/4” bolts, locknuts and steel washers. SEE fIGuRE 2. You must
now tighten all nut & bolt assemblies. Be sure not to over tighten or
crush tubing when tightening!
5. Sections are assembled on the ground in the following order: bottom section
(SL62 ladder); second section (SL62 ladder); third section (SL63 ladder with
stabilizer bar mount); fourth section (assembled SL64 ladder with foot
platform); top section (assembled top sitting section). SEE fINIShED 13’
PACk-N-STACk lADDER lINE ART.
Figure 1
Figure 2
1/4-20 x 2-1/4" bolts
steel washers
side rails
tree blade frame
locknuts
locknuts
foot platform flat bars
1/4-20 x 2-1/4" bolts
mesh foot platform
1/4-20 x 1-1/2" bolts
2-step ladder
w/stabilizer
bar mount
WARNING
fOOT PlATfORM AND SITTING SECTION MuST AlWAYS
fACE ThE SAME DIRECTION, TOWARDS ThE TREE.