Rivers Edge RE602 JOURNEYMAN - Manual (Page 11)

Check for parts online at www.huntriversedge.com or call 800-450-EDGE (3343) M-F 8-5 11
Operator's Manual
Rivers Edge One-Man Ladder Stands
ASSEMBlY INSTRuCTIONS (RE604)
Tools needed – two 7/16" wrenches
IMPoRtant assEMBlY tIP: do not tighten any nut and bolt combinations
completely until all parts are assembled together! Finger tighten plus one
turn of a wrench only! this will temporarily hold the lock nut on the bolt while
helping alignment of all parts! after all parts are assembled together, all nut
& bolt combinations must be completely tightened.
1. Attach the foot platform (112ML51) to the inside of flared rails (112ML61)
using (2) provided 1/4-20 x 2-1/4" bolts and locknuts. SEE fIGuRE 1. DO
NOT tighten all nut & bolt assemblies completely!
notE: Mesh surface should be on top with squared ends of platform clos-
est to flared rails.
2. Attach the foot platform flat bars (AL7) to the inside of flared rails and the
outside of foot platform using (4) provided 1/4-20 x 1-1/2" bolts and locknuts.
SEE fIGuRE 1.
3. Attach the seat frame (112ML63) in between the side rails (112ML60), and
the armrests (LFX5) to outside of side rails using (4) provided 1/4-20 x 3"
bolts, locknuts and steel washers. SEE fIGuRE 2.
notE: Mesh surface should be on top with squared ends of seat frame
closest to ends of side rails.
4. Attach the (2) tree blade extension tubes (112ML62) to the bottom side of
seat frame using (4) provided 1/4-20 x 2-1/4" bolts, locknuts and steel
washers. SEE fIGuRE 3.
5. Attach the tree blade (2ML130) to the top side of tree blade extension tubes using
(2) provided 1/4-20 x 2-1/4" bolts, locknuts and steel washers. SEE fIGuRE 3.
6. Attach the (2) shooting rail mounts (112ML53) to the side rails using (2)
provided 1/4-20 x 1-3/4" bolts and locknuts. SEE fIGuRE 3. You must now
tighten all nut & bolt assemblies. Be sure not to over tighten or crush
tubing when tightening!
Figure 1
1/4-20 x 1-1/2” bolts
locknuts
foot platform
foot platform flat bars
locknuts
1/4-20 x 2-1/4” bolts
flared rails
locknuts
side rails
seat frame
1/4-20 x 3” bolts
Figure 2
armrests
steel washers
Figure 3
shooting rail mounts
1/4-20 x 1-3/4" bolts
tree blade extension tubes
1/4-20 x 2-1/4" bolts
steel washers
tree blade
side rails
seat frame
locknuts