RECON 264146 RAM Cab Light (Dodge) - Manual (Page 11)

11 | P a g e
- You Are Now Set To Wire -
Wire and Cab Light Install
-There Are Many Ways To Wire to Your Cab Lights. There Is No Harm Is Using Wire Nuts, Butt
Connectors, or The Method I Chose - Soldering. I Decided To Make 2 Wiring Harness's, One For The
Negative, and One For The Power.
Building The Harness
-Start off By Cutting A Piece of Wire Long Enough To Reach From The Driver Side Cab Light to The
Bottom of The Passenger Side Pillar
-Put One End of The Wire In The "Wire Hole" on The Roof Drivers Side
-Now With Your Marker, Stretch Out The Wire Under Your Roof (Above The Headliner) and Mark On The
Wire Where Each Cab Light Hole Is. (4 Marks)
-Where Your Marks Are, Cut Out A Section of The Insulation To Expose The Bare Wire.
-Now Cut 4 Strips of Wire Approx. 6" Long, and Strip The Ends.
-Twist The Strips around The Splices on The Main Length
-Now Solder The Wires Together To Create A SURE Connection