Kasco Marine Robust-Aire - Manual (Page 5)

5
Parts included in RA(H)2-NC and RA(H)3-NC Sys-
tems:
• (2) or (3) Robust-Aire Diffuser Assembly
• (2) or (3) 3/8” x 100’ SureSink Tubing w/fitting kit
• (1) Double Head Compressor
• (1) ¼” NPT x 3/8” barb brass elbow
• (4) Compressor Vibration Isolation Feet
• (1) 3’ length of 3/8” hose
• (2) Hose clamp
• (1) Two or Three Station Manifold Assembly
• (2) Manifold Mounting Screw
Parts included in RA(H)4-NC, RA(H)5-NC and
RA(H)6-NC Systems:
• (4 - 6) Robust-Aire Diffuser Assembly
• (4 - 6) 3/8” x 100’ SureSink Tubing w/fitting kit
• (2) Double Head Compressor
• (2) ¼” NPT x 3/8” barb brass elbow
• (8) Compressor Vibration Isolation Feet
• (2) 3’ length of 3/8” hose
• (4) Hose clamp
• (2) Two or Three Station Manifold Assembly
• (4) Manifold Mounting Screw
Installation Tools & Materials
• Phillips Screwdriver
• 5/16” socket wrench or Flat Screwdriver
• PTFE thread sealant (Teflon tape)
No Cabinet System Installation
Requirements
Correct installation is your responsibility. Make sure
you have the proper installation conditions and that
installation clearances do not block air flow.
• Compressor needs to be installed in a clean, dry
location.
• Compressor needs to be protected from dirt and
moisture and from the outdoor environment such
as rain, snow, flooding.
• Ambient air temperature (temperature readings
taken 4” away from any surface of the compressor)
must not exceed 104° F (40°C).
• Adequate ventilation and cooling air (air flow
across the compressor) must be provided to keep
the compressor from overheating and causing pre-
mature damage.
3/8” Lead hose from
compressor
3/8” Clamp
3/8” x 3/8” Barb Fitting or
3/8” x 5/8” Barb Fitting
3/8” or 5/8” Clamp
3/8” or 5/8” tubing
Caution: Do not over tighten clamps.
19. Trench and bury tubing from the compressor to the
shore.
-NC Systems
Parts included in RA(H)1-NC Systems:
• (1) Robust-Aire Diffuser Assembly
• (1) 3/8” x 100’ SureSink Tubing w/fitting kit
• (1) Single Head Compressor
• (1) ¼” NPT x 3/8” barb brass elbow
• (4) Compressor Vibration Isolation Feet
• (4) ¼” Flat Washer
• (4) ¼” Lock Nut
• (1) 3’ length of 3/8” hose
• (1) Hose clamp